MasterCraft 54-2903-2, Owner'S Manual, Page: 26 / 37

26
DRILLING
When drilling into smooth, hard surfaces
such as metal, use a centre punch to mark
the desired hole location. This will prevent
the drill bit from slipping off centre as the
hole is started.
ASSEMBLY AND OPERATING
!
For safety reasons, the operator
must read the sections of this
Owner’s Manual entitled “GENERAL
SAFETY WARNINGS”, “POWER
TOOL SAFETY”, “SPECIFIC SAFETY
RULES”, “BATTERY & CHARGER
SAFETY” and “SYMBOLS” before
using this hammer drill.
Verify the following every time the
hammer drill is used:
1. Safety glasses, safety goggles,
or face shield is being worn.
2. Hearing protection and dust
mask are being worn when
using the drill in “hammer”
mode.
3. The chuck has not worked loose
on the spindle.
4. A hammer rated drill bit is being
used when drilling in “hammer”
mode.
5. The bit is in good condition, and
is properly tightened into the
chuck.
Failure to observe these safety rules
will significantly increase the risk of
injury.
WARNING
!