MasterCraft 54-2903-2, Owner'S Manual, Page: 20 / 37

20
INSTALLING THE DEPTH STOP ROD
The depth stop rod is used as a gauge to
control the depth of the drilled hole. The
depth stop rod can be used with the
hammer drill in either the normal drilling
mode or in the hammer drill mode.
1. Turn the auxiliary handle (1) counter
clockwise about three turns to open
the depth stop rod mounting clamp (2)
(Fig. 10).
2. Insert hexagonal end of depth rod (3)
into the matching hole (4) in the depth
stop rod mounting clamp.
3. Position the depth stop rod so the tip
of the round end will contact the
workpiece when the drill reaches the
appropriate depth.
4. When the depth stop rod is properly
positioned, tighten the depth stop rod
mounting clamp by turning the
auxiliary handle clockwise. Tighten by
hand only.
NOTE: Tighten the handle by hand only.
Do NOT overtighten or you will damage
the handle or housing.
TWO-SPEED GEAR BOX SWITCH
Set the speed-control switch (1) to the
desired speed (Fig. 11). Slide the speed-
control switch FORWARD for low-speed
operation. Slide the speed-control switch
BACK for high-speed operation.
ASSEMBLY AND OPERATING
Fig. 10
Fig. 11