MasterCraft 54-2903-2, Owner'S Manual, Page: 21 / 37

21
TWO SPEED GEAR BOX SWITCH
– Cont’d
NOTES:
a) Use low-speed setting for drilling large
holes and for driving screws.
b) Use high-speed setting for drilling
smaller holes.
c) Do NOT change the speed-control
switch position while drill is turned ON.
Damage to the gears may result.
FORWARD/REVERSE SWITCH
The forward/reverse switch (1) is
conveniently mounted above the trigger
switch (2) (Fig. 12). To make the drill rotate
clockwise for drilling or driving screws,
push the forward/reverse switch to the left.
To make the drill rotate counter-clockwise
for removing screws, push the
forward/reverse switch to the right.
NOTES:
a) The auxiliary handle has been removed
for illustrative purposes.
b) Never change the position of the
forward/reverse switch while chuck is
turning.
c) The trigger switch will NOT function with
the forward/reverse switch in the middle
position.
SPIRIT LEVEL
The drill is equipped with a dual reading
horizontal/vertical level to assist in keeping
the drill “level” while drilling horizontal and
vertical holes.
The horizontal level (1) is located in the top
of the drill housing (Fig. 13). The vertical
level (2) is located on the rear of the drill
housing.
ASSEMBLY AND OPERATING
Fig. 12
Fig. 13