22
INSTALLING IMPACT SOCKETS FOR
7/16" to 3/4" NUTS
1. Insert the hex end of the socket
adapter (1) into the hex drive (2)
(Fig. 13).
2. Select the correct socket size.
3. Push the square end of the socket (3)
onto the matching square end of the
adaptor (4).
NOTES:
a) See Fig. 6 for complete procedure.
b) Make sure the socket is fully installed
onto the square portion of the adapter.
REMOVING NUTS
1. Press the forward/reverse button to
the RIGHT for removing nuts (Fig. 7).
2. Place the socket fully onto the nut.
3. Hold the nut driver socket and impact
driver firmly against the nut with both
hands. With the nut driver aligned with
the nut, squeeze the trigger switch to
start the impact driver and remove the
nut.
NOTE:
When removing fasteners, do not
allow the impact driver to operate more
than 5 seconds unless the fastener begins
to turn. If the fastener fails to turn within 5
seconds, reverse the direction of rotation
and operate the impact driver in a forward
direction on the fastener for a few
seconds. Now switch back to reverse
direction and remove the fastener. This
procedure will usually break loose seized
or “frozen” fasteners.
ASSEMBLY AND OPERATION
Fig. 13
