Masterclock NTDS-A User Manual – Original – 2013-04-25
6
Mounting
You can mount your Masterclock Display according to your
needs. Appropriate brackets should already be included in your
kit.
DESIGNED FOR WALL, RACK OR TABLE MOUNT
Your Masterclock Display is designed to fit a variety of surfaces
and environments supported by these sturdy brackets.
WALL MOUNT BRACKET
A wall mounting bracket is supplied which has been designed to
fit on either a standard 2”x 4” or 4” x 4” conduit box. Mount the
bracket on the wall/conduit box, attach the power cord and
CAT5 or TC cable and secure the Masterclock Display to the
bracket using the supplied retaining screws.
SWIVEL MOUNT BRACKET (OPTION)
First, mount both swivel brackets to the wall, then attach the
signal input cable(s) and power cord and finally secure the
Masterclock Display to the swivel brackets using the supplied
retaining screws. Angle up or down to provide the best viewing.
Finally, tighten all screws.
TAKE CARE DURING INSTALLATION
Power and low voltage signal wiring should be installed
according to local electrical codes and to enable access to the
back of this device.
Do not route power or signal cables between the case and the
wall (along the exterior of the wall), which may pinch the power
or signal cable and create a hazardous condition.
