Master MT Professional 50, Instructions For Use And Maintenance Manual, Page: 33 / 58

33
www.masterproducts.es
6
9
11
8
7
10
12
With Allen key No. 5 (P) loosen, without removing, the two side
bolts shown in the following image, and repeat the same process
with the two bolts on the opposite side.
Once the blades are levelled, remove the grid and fix the two side
bolts on both sides with the help of Allen key No. 5 (P), as shown in
the following image.
Replace the protection grid and fix it with the help of the four
latches.
Replace the protection grid and fix it with the help of the four latches. Screw in or unscrew the threaded studs to raise or lower the blades as
required. Measure the distance between the two ends of the blades and the grid with a caliper or other measuring instrument as shown in
the following image.
The red coloured support in the following image has been
released and is free to move. Screwing or unscrewing the four
threaded studs on it and enabled for this purpose allow the blades
to be levelled, but before doing that, the grid must be placed as
described in the next step.
Next, tighten the four nuts shown in the following image, using the
Allen key No. 3 (N) and fixed spanner No. 10.
Finally, replace the container and fix it with the help of the two
retaining knobs (F).
=
=
=
=
If the distance is not the same, it will be necessary to adjust the height, screwing or unscrewing the threaded studs, as
appropriate.