Master MORFEUS MAS-HG12, Assembly Instructions Manual

Page: 56 / 79

56
EN
ASSEMBLY INSTRUCTIONS (C)
1. Slide height adjustment (M) over the guide upright (J). Lock with speed pin (16).
2. Attach turn pulley block (L) to height adjustment (M) with M12 lock nut + big washer (40).
3. Attach top cross beam (X) to main vertical beam (G) and guide upright (J) with bolt M10*70 + washers
+ nut (30).
4. Make the guide rods (H) in the holes of the side cross beam (AB). Attach side cross beam (AB) to top
cross beam (X) with bolt M10*20 + washer (24).
5. Attach metal shell (K) to side base (AJ) and side cross beam (AB) with bolt M8*16 (20).
6. Attach press bar (Y) to top cross beam (X) with small join tube (AE) and bolt M12*235 + w
lock nuts (18).
7. Attach left & right chest support (AA) to angle adjustment (Z) with bolt M10*70 + w nut (30).
8. Attach angle adjustment (Z) to press bar (Y) with small join tube (AE), bolt M12*235 + w lock
nuts (18) and special pin (43).
9. Attach speed ball board (AU) to speed ball rack (AT) with bolt M10*70 + nut (25).
10. Slide speed ball rack (AT) onto guide upright (J), screw with speed pin (16).