10
Salt Amount Setting
1) Press the SET button. The screen will show the Salt Amount as pounds
in blinking numbers.
2)
DO NOT CHANGE THE NUMBER
.
3) Press the SET button.
Softening Capacity Setting
1) Press the SET button. The screen will show the Capacity as grains in
blinking numbers.
2)
DO NOT CHANGE THE NUMBER
.
3) Press the SET button.
Hardness Setting (the factory default is 10)
1) Press the SET button. The screen will show the Hardness as grains per
gallon in blinking numbers.
2) To change the number, use the UP or DOWN arrows.
3)
Press the SET button.
Note: The screen will now flash between flow rate and
gallons remaining until next regeneration.
If water was tested by Master Water Conditioning, follow
recommendations on water analysis, for hardness
setting.
Final Check:
1. Fill the brine tank with Solar Salt and the Res-Up Feeders with Res-Up (one
quart is provided).
2. Make sure the drain line connection meets all plumbing codes and that the
drain line size can handle the backwash flow rate of the softener.
3. Make sure the Inlet and Outlet on bypass valve are open.
4. Make sure the control valve timer is plugged into an electrical outlet with
power 24 hours per day.
5. Check all piping for leaks.
