8
Filling Combination unit with Water:
1. Connect the MP-MCA control valve transformer into the electrical
outlet provided.
2. Press and hold the REGEN button until the drive motor starts.
When the drive motor stops, the display will read “BACKWASH”
position.
3. Open the inlet ball valve a ¼ turn of its full open position to allow
water to enter the water combination unit mineral tank slowly. The
water is going to enter the tank from the bottom of the distributor
pipe and leave the tank from the top. This will slowly purge all the
air from the tank.
IF WATER ENTERS THE TANK TOO FAST, ALL THE CATION
RESIN WILL BE FLUSHED TO DRAIN DURING START UP.
4. When only water is running to the drain, open the inlet and outlet
ball valves fully.
5. Press the REGEN again until the drive motor starts. When the
drive motor stops, the display will r
ead “BRINE” position.
6. Press and hold the REGEN button until the drive motor starts.
When the drive motor stops, the display will read “RINSE” position.
The fast rinse position will rinse the combination unit tank.
7. The control valve will automatically advance to the brine refill
position where the brine tank will fill with the proper amount of
water. The display will read “FILL”.
NOTE: THE TIMER WILL AUTOMATICALLY ADVANCE TO THE
SERVICE POSITION AND THE DISPLAY WILL READ THE
CAPACITY REMAINING, IN GALLONS.
