17
VARIABLE-SPEED TRIGGER SWITCH
This drill is equipped with a variable-speed
ON/OFF trigger switch.
1. To start drill, gently squeeze the
trigger switch (2) (Fig. 7).
NOTE:
The drill will turn at its slowest
speed when the trigger switch is
depressed slightly. The drill will turn at its
fastest speed when the trigger switch is
fully depressed.
2. To stop the drill, release the trigger
switch.
NOTE:
Drilling at a slow speed for an
extended period of time may cause the drill
motor or the battery pack to overheat. If
either the drill or the battery gets hot, stop
drilling and allow them to cool for at least
15 minutes.
INSTALLING DRILL BITS
WARNING:
Never hold the chuck
body with one hand and use the drill
power to rotate the drill body to loosen
or tighten bits. Serious injury may
result.
This drill is equipped with a double sleeve
keyless chuck.
1. To open the keyless drill chuck, grasp
and hold the chuck collar (1) with one
hand (Fig. 8). Rotate the chuck body
(2) with the other hand in a counter
clockwise direction (3) until the chuck
jaws (4) open wide enough to accept
the bit (5).
ASSEMBLY AND OPERATING
Fig. 7
!
Fig. 8
Summary of Contents for 134454
Page 25: ...25 EXPLODED VIEW ...
