Master-force 241-0854, Operator'S Manual

Page: 14 / 24

Page 13
OPERATION
236-0851 236-0852 236-0853 236-0854 236-0855
236-0856 236-0857 236-0858 236-0859 236-0863
236-0864 236-0865 236-0866 236-0867 236-0868
236-0869 236-0870
ATTACHING THE APPLICATION ACCESSORY
USED FOR UTILA-TOOL 241-0853
The Utila-Tool can be used with Fein
®
brand oscillating tool accessories and Menards accessories.
The model numbers for the Menards Utila-Tool 241-0853 accessories are listed in the following table.
1. Disconnect the tool from the power source.
2. Push the quick-release lever fully open
with your palm to loosen the flange bolt
(Fig. 5). Remove the flange bolt.
3. Loosen the two screws in the adapter,
and remove the screws and the adapter
(Fig. 9). Place the attachment in a safe
place for future use.
4. Ensure that the inner threads and the
drive shaft are clean.
5. Align the grooves on the application tool
with the four raised ribs on the drive
shaft. Put the application tool onto the
drive shaft (Figs. 10 and 11).
6. With your gloved hand holding the
application tool, insert and depress
the flange bolt until you hear a click
indicating that the application tool is
secured.
7. Press the quick-release lever with your
palm to lock the drive shaft.
FIG. 9
FIG. 10
FIG. 11
Screws
Rib
Groove
NOTICE: Attach the Fein
®
brand
application tool at the desired orientation
for the task at hand. The shaft is
configured so that the application tool can
be attached at 45° intervals around the
shaft, from 0° to 315°.