5.3 Locate fire
inside the frame:
-
Lift the semi-dismantled fire from the pellet; put it on the support shelf.
-
Screw and fix supplied steel angles into the front nogs. Ensure that first steel angle is at a correct height and both angle faces are
flush with the front nogs of the frame. Refer location of first angle and orientation on schematic given on page 9.
-
Centralize the entire fire horizontally within the built in cavity.
-
Simultaneously, using piece of non-combustible front cladding material as a gauge, position the flanges of fascia forward, out of
cavity face by thickness of the front cladding material. (Refer schematics below)
-
Once the fire is centered in both directions, mark and drill required holes on the side flanges of the fire.
-
Use appropriated fastening to anchor the fire into built- in cavity.
-
Remove fascia by unscrewing six screws, 3 on each of the side flanges using 4mm Allan key provided with the fire.
Page | 12
