7
Assembly Instructions
Product Description
Carton Identification
Product Part Number
Open the carton by removing the
shipping straps then slitting along both
ends. Cut the tape only by a small
amount in the middle, finish by lifting
the carton flaps with your hand.
Unpack the entire carton, this carton
will be used as a surface protector as
the cabinet is being built. Open the
carton as shown and place where the
BBQ will be assembled
Note: Letters in the bracket after every screw, helps you identify the item number from the parts list on page 6, from the fastener kit.
Tools needed for assembly
Crosshead screwdriver, 10mm A/F Spanner
Open the fastener kit, place to one side, 4 pcs screw (SS) M6x12 (b) & 4pcs fibre washer (c) for Hood Assembly.
1. 1) Remove the screws , nuts and the washers fastened to the Weight Plate.
2) Fix the weight Plate (32) under the base tray (1) with these 2pcs Screw M6*40 (g) 2pcs washer, (h) 2pcs Nut M6 (f).
1
Screw M6*40
32
Washer
Nut M6
2. Assemble 1pc Front skirt (2) to the Base tray (1) using 2pcs Screw M6×12 (a) from the fastener kit.
2
Screw M6*12
3. Assemble 1pc Left skirt (3) to the Base tray using 3pcs Screw M6×12 (a) and 1pc Screw M5*10(d) from the fastener kit.
3
Screw M6*12
Screw M5*10
