Model: LC5296-AT /LC5248E-AT/LC5296V-AT
masibus
Doc. Ref. no. : - m61C/om/301
Issue no. 13
User’s Manual
Page 16 of 44
%Power.
SET-1
Key/ SET-
2 Key
(Menu /
Enter
Key)
For Linear Output, Shows Alarm Set Point-1(A1.SP), if
pressed one time in RUN mode.
For Other Output Type, shows Control Set Point-1(C1.SP),
if pressed in RUN mode.
In Sub Menu it can be used to get to the next Parameter.
It is also used to save the parameters to nonvolatile
memory, when user setting a proper data by Increment
and decrement key for parameter configuration.
Shows Alarm Set Point-2(A2.SP), if pressed two times in
RUN mode. Shows Sok.t(Run/stop) if pressed three times
in RUN mode.
Auto/Man
ual Key
It is used to switch between Auto to Manual mode and
Manual to Auto mode if pressed for at least 2 sec if
function key is A/M.
Shows remaining soak time when pressed if function key is
selected SOK.T.
PV
(Process
Value)
Display
PV
4 digital 0.40 inch RED Display(for LC5248E-AT)
4 digital 0.36 inch RED Display(for LC5296V-AT)
Display process value.
Display parameter name when user set parameter
Display error message when an error occurs.
SV
(Set
Value)
Display
SV
4 digital 0.28 inch GREEN Display(for LC5248E-AT)
4 digital 0.31 inch GREEN Display(for LC5296V-AT)
Display set value.
Display parameter value of parameter in process value
field when user set parameter.
Display control output value when in manual mode.
Relay-1
Indication
RL1
ON when Relay-1 is energized & OFF otherwise.
Relay-2
Indication
RL2
ON when Relay-2 is energized & OFF otherwise.
SSR
Indication
SSR
SSR ON status.
MANUAL
Indication
MAN
ON when unit is in Manual mode.
OFF when unit in Auto Mode.
TX
Indication
Tx
ON when device is transmitting some Data (RS-485).
RX
Indication
Rx
ON when device is receiving some Data (RS-485).
