Masibus HT16Ew, User Manual

Page: 19 / 26

Ref. No: m94A/OM/201
Issue No: 01
Operator’s manual
Page 19 of 26
reset minimum value. If user will press “
S.Y
” (DCR Key) then it will reset minimum
value to default.
(9)
Max dft
Maximum Value Reset (Default) Mode:
Max dft
stands for Maximum Value Reset mode. It is user input menu.
On the press of MENU key, save Yes/ save No (
S.Y
/
S.n
) screen will appear for saving
new changed maximum reset value. If user will press “
S.n
” (INC Key) then it will not
reset maximum value. If user will press “
S.Y
” (DCR Key) then it will reset maximum
value to default.
(10)
usb.d
USB configuration Mode:
This mode is specially designed to configure device type of HT16Ew via USB configuring
cable & mCRM Tool
. Unit can be configured as either T+RH, T or RH.
To configure device type of HT16Ew unit user has to 1
st
go in
usb.d
menu. On the
press of MENU key, save Yes/ save No (
S.Y
/
S.n
) screen will appear. If user will press
“
S.n
” (INC Key) then it skip current mode. If user will press “
S.Y
” (DCR Key)
usb.d
on
screen will appear which shows unit is ready to communicate with mCRM Tool.
After that connect HT16Ew configuration cable to laptop and select appropriate COM
port. User can set/get configuration as shown in below screen:
Once configuration is over user may exit
usb.d on
mode as mention in menu-layout.
If unit stays inactive or idle in this mode then after 90sec device will resume to run-
mode automatically and communication with mCRM tool is terminated.
8.4
xbee
(Xbee Radio menu):
It is user configurable radio menu use for setting various radio network parameters like
network id, device type etc.
(1)
End.don
(End device Enable) Mode:
End.don
mode used to configure transmitter unit as “end device (Sleeping Device)”.
On the press of MENU key, save Yes/ save No (
S.Y
/
S.n
) screen will appear for saving
new change. If user will press “
S.n
” (INC Key) then it will discard the new changes. If
user will press “
S.Y
” (DCR Key) then it will set unit as “end device” device.