Maserati Levante 2019, Owner'S Manual

Page: 307 / 454

5
307
Driving
Speed km/h (mph)
Engaged/activated 60 (37)
Maximum 180 (112)
System Limitation
Because of physical limits the system
to properly operate needs good
visibility (it might not work or not
properly operate in case of heavy
rain, snow, wet roads, fog, direct sun
on the camera, dirty windshield, low
illumination etc.)
Sharp turns, slopes and change in
slopes, poor lane boundaries, as well
as construction areas and all the
scenarios described in this paragraph
may challenge the system, therefore
be always ready to prevent any
unexpected behaviour of the car.
Damaged front bumper, windshield
replaced without proper technical
intervention may also lead to system
malfunction or system unavailability.
Other conditions such as faults, but
not explicitly indicated here may
also prevent/interrupt the system
intervention.
ABSA Setting
ABSA is configurable by the customer
in order to maximize its efficiency
based on the driver driving style and
his/her expectation of the system,
reducing at the same time the possible
invasiveness.
Setting modes can be selected
from the MTC+ System (see "MTC+
"Controls" Screen" in section
"Dashboard Instruments and Controls"
for further information).
Touch "Controls" soft-key on
(Apps)
page to display the current status of
the ABSA system, if it was in the on
state.
To change status, touch the "Active
Blind Spot Assist" soft-key.
To change the system setting, touch
the soft-key on the side.
Driver warnings can be only "Visual",
"Visual & Acoustic" (default mode) or
"Visual & Haptic".
System sensitivity can be set to “Early”,
“Medium” (default mode) or “Late”.
System strength can be set to "Low",
"Medium" (default mode) or "High".
NOTE:
The ABSA system will store the current
operating mode when the vehicle
is shut off. Each time the vehicle is
started, the previously-stored mode
will be recalled and used.
Meanings of Settings
When "Visual & Haptic" is selected and
of course ABSA is enabled, then two
following menus will be used by the
system.
• ABSA “Sensitivity": it tunes the
distance to the lane boundary
concerned where the system will start
to apply steering torque.
• ABSA “Strength": it tunes the
steering torque value increasing
or decreasing it to have a stronger
or weaker trajectory correction/
deviation.