Maserati Ghibli 2021, Owner'S Manual

Page: 63 / 382

2
61
Understanding the Vehicle
HomeLink ® ( )
HomeLink ® replaces up to three
hand-held transmitters operating the
automatic devices that open garage
doors and gates, enable/disable
the lighting or security systems.
The HomeLink
® unit is powered by
your vehicle's 12 Volt battery. The
HomeLink
® buttons that are located in
the overhead console designate the
three different HomeLink
®
channels.
The HomeLink ® warning light is
located in front of the buttons.
NOTE:
HomeLink ® is disabled when the
vehicle security alarm is active ( :
chapter “Vehicle Security Alarm” in
section “Safety”).
WARNING!
•
Your motorized door or gate
will open and close while you
are programming the universal
transceiver. Do not program the
transceiver if people, pets or other
objects are in the path of the door or
gate. Only use this transceiver with
a garage door opener that has a
“stop and reverse” function. Do not
use a garage door opener without
these safety functions. Call toll-free
1
–
800
–
355
–
3515 or, on the Internet
at www.HomeLink.com for safety
information or assistance.
• Vehicle exhaust contains carbon
monoxide, a dangerous gas. Do
not run your vehicle in the garage
while programming the transceiver.
Exhaust gas can cause serious injury
or death.
Before You Start Programming
HomeLink
®
Be sure that your vehicle is parked
outside of the garage before you
begin programming.
For more efficient programming and
accurate transmission of the radio-
frequency signal it is recommended
that a new battery be placed in the
hand-held transmitter of the device
that is being programmed to the
HomeLink
® system.
Before starting programming it is
necessary to erase the standard codes
memorized on the HomeLink
®
device
during the production phase. To erase
such codes:
• place the ignition device in the
RUN
position without starting the engine;
• press and hold the two outside
HomeLink
®
buttons (I and III) until
the warning light starts flashing
(after approximately 20 seconds);
• release the buttons.
NOTE:
• Erasing the standard codes
should only be performed when
programming HomeLink
®
for the first
time. Do not perform this operation
to program additional buttons.
• If you have any problems, or
require assistance, please call
toll-free 1
–
800
–
355
–
3515 or, on the
Internet at www.HomeLink.com for
information or assistance.