cod. F07011388
1
2
TABELLA COPPIE DI SERRAGGIO VITI (valori espressi in Nm)
- CHART: SCREW TIGHTENING TORQUES
(settings given in Nm) -
TABLEAU COUPLES DE SERRAGE DES VIS (valeurs exprimées en Nm)
TABELLE DER ANZUGSMOMENTE DER SCHRAUBEN (Werte in Nm ausgedrückt)
-
TABLAS PARES DE TORSION TORNILLOS (valores expresados en Nm)
CLASSE -
CLASS
CLASSE -
KLASSE-
CLASE
VITE PASSO FINE
FINE PITCH SCREWS
6.6 8.8 10.9
12.9
VIS A PAS FIN
S
CHRAUBE STEIGUNG FEIN
TORNILLO PASO FIN
M8 x 1
15 26 36
44
M10 x 1.25
30 52 74 88
M12 x 1.25
51 91 127
153
M14 x 1.5
81 143 201
241
M16 x 1.5
120 214 301
361
M18 x 1.5
173 308 433
520
M20 x 1.5
242 431 606 727
M22 x 1.5
321 571 803 964
M24 x 2
411 731 1028
1234
M27 x 2
601 1070 1504
1806
M30 x 2
832 1480 2081
2498
fi
g.51
fi
g.52
fi
g.53
USE AND MAINTENANCE
ENGLISH
68 - EN
Repeat the operation if necessary, remembering to unscrew one
turn at a time. If the clutch maintains a temperature of about 40-50
degrees during work, this means that it has been correctly regulated.
Never fully torque the nuts since this would void the function of
the springs and, subsequently, of the clutch, thus damaging the
transmission components.
CAUTION
This inspection must be performed at the beginning of each
new working season.
Driveline with cam type torque limiter
This device protects the transmission components of the machine
from stress and excessive overloads.
Drive transmission actually stops in the case of an overload and is
automatically engaged again by reducing the rpm rate of the PTO.
CAUTION
Avoid frequent and lengthy overloads.
The driveline is supplied calibrated by the Manufacturer.
Do not tamper with the device if operational faults occur.
Contact the driveline supplier or a specialized center if nec-
essary.
