Maschio EXTREME 266 HTC, Use And Maintenance

Page: 216 / 240

ENGLISH
USE AND MAINTENANCE
Page 214 Cod. F07022408
STORAGE
IMPORTANT!
If these operations are carefully done you will have the benefit of a machine in excellent condition that is
ready to resume work.
If the machine is to be scrapped, respect the laws in force regarding pollution and the disposal of
lubricants in your country.
WARNING!
DANGER OF GETTING CAUGHT IN MOVING PARTS OF THE MACHINE.
POTENTIAL CRUSHING OR SHEARING OF THE LIMBS.
POTENTIAL SERIOUS INJURIES OR DEATH.
Before any work on the machine:
•
Take heed of all basic safety regulations, as contained in chapters “GENERAL SAFETY
REGULATIONS”.
STORAGE OF THE MACHINE
At the end of the season, or if a long period of rest is foreseen, the following instructions should be followed:
•
Make sure that the machine is completely unloaded.
•
Release the pressure in the hydraulic circuit.
•
Store the machine in a closed area under surveillance in order to prevent the entry of unauthorised persons.
•
Keep the machine in a dry place, protected from adverse weather conditions.
•
To avoid accidents caused by unexpected movements, firmly place the machine on firm, flat and horizontal
ground.
Then lock the machine by operating the mechanical parking devices.
•
Make sure that all the guards on the machine are in their correct positions.
•
Thoroughly clean the machine, dirt attracts humidity and as a result the metallic parts can rust.
•
Inspect everything carefully and if necessary replace any damaged or worn parts.
•
Carefully lubricate all the required points, apply antirust or oil or grease to all the metallic parts not covered
with paint or with paint peeled off to protect from rust.
•
Oil the blades of the binders, clean and oil all the chains.
•
Grease all the exposed parts of the cylinder rods and electrical actuators.
•
Clean the belts and check the condition of the clinches (fasteners).
•
Install the device against unauthorised use on the towing eye.
•
Cover the baler with a plastic sheet.
STORING THE ICON SYSTEM
•
Remove the control terminal and place it in its box.
•
Keep them in a dry place protected from inclement weather, dust, humidity, insects and rodents.
STORAGE OF THE CARDAN SHAFT
•
Remove the cardan shaft and place it in a dry protected place.
For further information read the instruction and maintenance booklet of the cardan shaft provided together
with it.