Wrapper
5100
WARNING
Before to transport or to use the machine
must to be sure that the screws for the
block are tightened.
fig. 13 – Filmstretching height setting
4.4.3 REEL
INSTALLATION
To install film reel you must to proceed as follows
(vedi fig.14):
1- Move the rolls away from the support reel
pushing the lever (A). At the end of the
stroke the rolls will be coupled up on the
stop (B).
2- Push the upper plug (C) towards the top
till hooking release.
3- Charge the reel leaning it on the lower
plug (D) first, then aligning it with the
upper plug (C).
4- Pull the rope (E) to couple up the upper
plug (C).
5- Pass the film around the rolls as indicated
on fig. 16.
Note: the operation is more simple if
you pass the film around the base of
the rolls.
6- Release the rolls pushing on the lever (A)
first and then pulling the block (B). Let the
outer roll to lean on the reel holding the
block pulled (B).
7- Pull film’s end and block it in the pliers.
fig. 14 – Reel installation
4.4.4 REEL USE H=500
To use reel with a height of 500 mm you must to
lift the lower plug and use adapter (C, fig.15) on
the lower part.
o lift the lower plug proceed as follows (fig. 15):
1- To loose the screw (A)
2- Take the plug shaft (B) in upper position
till the lever couple up on its site.
3- Block the screw (A)
fig. 15 – Height 500mm reel adapter
USE & MAINTENANCE MANUAL
- 22 -
