Z3
QR20
1
19
19
26
29
Dx.
Sx.
Nm
12
28
D
E
CROWN AND STANCHIONS
ASSEMBLY
FIG. 24
Fit the crown and stanchions assembly
(1)
- with the dust seals in place - gently into
the sliders seals.
IMPORTANT:
to avoid any damages to
sealing surfaces, keep the stanchions duly
lubricated and squared into the sliders.
Press the crown and stanchions assembly
fully down and check that threaded ends of
pumping elements
(14)
and
(12)
are com-
ing out through the bottom of the sliders.
Check to see that the stanchions slide
unrestricted by cycling the fork up and
down several times.
The tube should slide freely inside the seal
assembly without any side play. In the event
it is too hard or too soft, repeat the previous
steps described above and check compo-
nents to ensure they are not damaged.
Seat the dust seals
(19)
on top of the
sliders.
FIG. 25
Screw the foot nuts
(26)
and
(29)
on the
threaded elements of pumping elements
(14)
and
(12)
.
Tighten to 12 Nm.
Check to verify that the stanchions slide
properly through the stroke by pumping
them up and down several times.
FIG. 26
Fit the retainer
(D)
into the slider
(E)
to
reassemly the adjuster unit
(28)
.
