Installation
M
Z
010
English
3
88
3.4 Wheel installing with a standard
fork’s end
ATTENTION
Install the wheel in compliance with the bike
manufacturer’s instructions.
For correct fork function after wheel installing
you will need to:
• Check the correct fork-wheel alignment by
fully compressing the fork a few times.
• Lift the front wheel, turn the wheel a few times
to verify the correct alignment with the disk
brake or the Cantilever/V-Brake brake pads.
3.5 Wheel installing with a QR20 Plus
fork
For correct fork function, please follow the
instructions here below when installing the
wheel:
• Release the securing system on both legs by
pushing the levers (
A
) downwards and open
the flap (
P
).
• For quick-release hubs, open the release
lever (
B
).
• For threaded cap hubs, unscrew the cap (
C
)
as much as needed to insert the wheel axle
through the fork wheel axle clamp.
• Insert the wheel axle (
D
) through the fork
wheel axle clamp.
• Make sure that the wheel axle supporting
bushings (
E
) are centered in the sliders’ seat
• If the wheel axle is provided with quick-
release system, lock the wheel with the quick-
release lever (
B
); otherwise, tighten the cap
positioned on the axle side using a 6 mm
Allen key to the required tightening torque
(see Table - Tightening Torques).
• Verify the correct settling of the supporting
bushings (
E
).
• Check the correct fork-wheel alignment, by
fully compressing the fork a few times.
• Lift the front wheel; turn the wheel a few times
to verify the correct alignment with the disk
brake.
• Lock the securing system by pulling the levers
(
A
) upwards and adjust clearance through the
adjusters (
H
), if needed.
MZ
0010
37
E
B
D
A
C
P
MZ
001
038
B
A
E
H
C
Summary of Contents for QR20 Plus
