2022-09-08
17
Sliding Door Automatic Control Device
19916437
Installation Instructions
Programming
NOTE:
Summit will provide documentation on how to
properly program the system.
1. Initial Programming:
make sure both AC and DC
power to the system are turned off on the control box
cover. Place the lead panels to the halfway point of the
opening. Then turn on both AC and DC power.
2.
Press the "OPEN" button on the wall switch. The
panel will start to move. If the door is moving to the open
position, the polarity is correct. Let the panel move 24"
and then press "UNLOCK" on the wall switch. The door
will stop.
Figure 40
3.
If the polarity is incorrect and the door is closing,
press "OPEN" a second time and the door will change
polarity. Let the panel travel approximately 24" before
pressing "UNLOCK" and moving on to the next step.
4.
Manually move the door to the fully open position.
Press and hold the "UNLOCK" button until the touch
screen shows "Release Button!" or red and blue lights
blink rapidly (on non-touch screens).
Figure 41
5.
Move the door manually to the fully closed position.
Press and hold the "UNLOCK" button until the touch
screen shows "Release Button!" or red and blue lights
blink rapidly (on non-touch screens).
.
Figure 42
6.
Once the "UNLOCK" button is released, the door will
automatically cycle in programming mode.
WARNING!
The automatic stop feature is disabled in programming
mode. Make sure the opening is kept clear when pro-
gramming.
7.
Once the door stops and is engaged in the closed
position, the programming is complete.
