Optional Door Handle Installation for Panel
Ready Doors (for units without door handle
attached)
The door handle for certain doors may be packed
inside your ice machine and can be mounted on
the top or side of your refrigerator door. Locate the
handle where it is convenient for you. You will
need a 1/4" hex head driver to install the handle.
Place the handle on the outside surface of the
door. Push gently inward toward the door until the
handle snaps in place. Use the two screws sup-
plied to secure the handle to the door frame by
tightening the screws into the holes on the back-
side of the handle. Tighten the screws until the tips
of the screws touch the bottom of the backside of
the door frame. Your installation is complete.
Reversing the Door
You may want to change the side on which the
door opens and closes. This can be changed by
the following steps.
1. Remove the door by removing the top hinge
pin and angling the door off of the bottom
hinge pin.
2. Gently pry out the hole plugs on the side
which the hinges will be mounted. A thin
knife will usually allow the hole plug to be
removed just enough to pull the rest of the
way out by hand. Do not destroy these plugs
because they will be used on the other side
of the unit.
3. Remove the hinges from the unit.
4. Remove the hinge pin from the bottom hinge
that was removed. Install this pin on the
other hinge that was also removed.
5. Install the hinges on the desired side of the
unit.
6. Install the door by inserting the bottom door
bushing with the bottom hinge pin and
angling door in until top door bushing and
hinge line up. Install the upper hinge pin.
7. Install the hole plugs from step 2 in holes.
D O O R A LT E R AT I O N S
17
S E R V I C E PA R T S D I A G R A M O N E
10
