―
ES-4
―
2) Coloque la cuchilla que limita la longitud del nylon
utilizando el tornillo de 5x20 bloqueado con la tuerca
cuadrada. Ver Fig. 2 y Fig. 3.
3) Coloque la guía del protector en los agujeros como se
muestra en la fig 4. Asegurándose que las ganchos
Fig. 5 entran en la posición correcta.
(7) Cuchilla
1) Instale la cuchilla de la cortadora de maleza en el
adaptador de caja, luego instale la arandela de
agarre, el estabilizador de la cuchilla y el perno de la
cuchilla.
2) Alinee el agujero en el adaptador de caja con la
ranura de guía de la caja de engranajes.
3) Introduzca el perno de
φ
3,5 mm en el agujero del
adaptador de caja y en la ranura de guía en la caja de
engranajes para fijar el eje ranurado.
4) Apriete el perno de la cuchilla.
Nota: La cabeza de la cortadora tiene rosca de giro
a la izquierda.
ANTES DE OPERAR LA MAQUINA
COMBUSTIBLE: LA MEZCLA DE GASOLINA Y ACEITE
Los motores de dos ciclos que se usan en la Cortadora requieren como combustible una mezcla de GASOLINA y ACEITE para la
lubricación de cojinetes y otros elementos móviles. Las proporciones correctas de esta mezcla son
25 : 1
que corresponden a 40 cc. de
aceite en un litro de gasolina.
NOTA :
Siempre mezcle por anticipado la gasolina y el aceite en un recipiente limpio, aprobado para gasolina. Nunca mezcle la gasolina y
el aceite en un recinto interior o utilizando, para hacer la mezcla, el tanque de la máquina. Use siempre gasolina fresca.
¡¡ADVERTENCIA!! NUNCA USE EN MOTORES MARUYAMA GASOHOL O COMBUSTIBLES MEZCLADOS CON ALCOHOL.
Antes de llenar el tanque de combustible, limpie alrededor de la tapa del tanque para evitar que mugre o desechos entren al tanque
cuando se encuentra destapado. Cierre el recipiente y agítelo por un momento para mezclar bien el aceite y la gasolina antes de llenar el
Herramienta de
sujeción
(perno de
φ
3,5mm)
Perno de la cuchilla
Estabilizador
Cuchilla
de la
cortadora
Adaptador
de caja
Caja de engranajes
Arandela
Rosca hacia
la izquierda
Eje
ranurado
Fig.5
Gancho
Fig. 4
Extensión protector
Gancho
Protector de la Cuchilla
Guía
Fig.3
Cuchilla
Tornillo
M5×20