―
US-6
―
OPERATING THE BRUSHCUTTER
OPERATING POSITION
1. Set kanpsack belt as shown illustration.
2. When set it yourback, adjust length of belts to fit pads comfortably.
3. The Brushcutter should be on the operator’s right side.
4. The operator’s right hand should be holding the shaft grip, with his fingers on the throttle trigger.
5. The left hand should be holding the Loop handle with the fingers and thumb fully enclosed around the grip.
Reposition the Loop handle up or down the drive shaft if necessary for a comfortable position.
OPERATING UNIT
MARUYAMA Brushcutter are designed and tested to cut nearly all grasses,
thick weeds and brush. As you continue to use the equipment, many tasks will
become easier.
CAUTION
-Read the SAFETY INSTRUCTIONS concerning the proper use of
the brushcutter on page(US-1).
CAUTION
-Observe all warnings that appear on the Brushcutter.
CAUTION
-Use only the correct blade approved for the task and the machine.
CAUTION
-Always make certain the blade is installed to rotate in the proper
direction and that all holding and fastening parts are correctly secured.
CAUTION
-Remove the holding tool (ɔ3.5mm pin) before operating the equipment!
CAUTION
-Do not continue to use a blade that is dull, damaged, or that vibrates
during use. Whenever a cutting blade becomes clogged with debris,
immediately stop the machine and clean the blade.
CAUTION
-When cutting heavy blush or small trees, use the proper method to
avoid dangerous “KICK- BACK” (see sketch).
REGULAR MAINTENANCE
AIR FILTER
The filter should be cleaned each time the Brushcutter is used. (or
more often with extreme conditions.) Remove the filter cover and take
out the element. Wash the element in kerosene or warm detergent,
then squeeze it dry. Apply oil (#30 wt.) to foam, removing all excess
oil.
Assemble and reinstall air filter on carburetor.
Pad
Pad
Knapsack belt
Ring
Rubber band
Stay
