— 4 —
[BCF429H, BCF509H]
Caution! : This swivel stopper is exclusively for fixing the handle in trans-
port. Do not engage the swivel stopper while operating the brushcutter.
In transport:
Loosen the wing nut, place the stopper on A position of the bracket.
Tighten the wing nut, confirm the handle is fixed by the swivel stopper.
In operation: Before start operation of the brushcutter, disengage the swiv-
el stopper. Loosen the wing nut, place the stopper at B position. Tighten
the wing nut to fix there, confirm the handle becomes free to turn around.
BLADE GUARD
Attach the blade guard to the gearcase with the four M5
X
12 screws as
shown.
CUTTING BLADE
A variety of metal cutting blades are available to satisfy different cutting
conditions. It is especially important to use only the correct blade(s)
approved for each model brushcutter. Also, it is especially important to
install the blade for LEFT- HAND rotation (as viewed from the operator's
position), and to correctly position all blade holding parts (see sketch).
BEFORE OPERATION
FUEL : MIXING GASOLINE AND OIL
The two cycle engines used in the brushcutter requires a mixture of
GASOLINE and OIL for lubrication of bearings and other moving parts. The proper fuel mixture ratio is 25 : 1,
which is 40cc of oil mixed with one liter of gasoline.
NOTE : Gasoline and oil must be premixed in a clean gasoline container. Never mix gasoline and oil indoors or
in the burushcutter fuel tank. Always use fresh gasoline.
WARNING !! - NEVER USE GASOHOL OR ALCOHOL BLENDED FUELS IN MARUYAMA ENGINES.
Before filling the brushcutter fuel tank, clean around the fuel tank cap so dirt and debris does not enter the fuel
tank. Always shake the fuel container before filling the fuel tank. Remove the fuel cap, then fill the fuel tank to
within about 10mm from the top of the tank. Avoid filling the fuel tank filler neck. Install the cap securely onto the
fuel tank.
Blade Guard
Gearcase
Screws (4)
Bracket
Swivel
Stopper
Wing Nut
Blade Guard
Gearcase
Screws (4)
Stabilizer
Blade Bolt
Left-hand
thread
Washer
Brushcutter Blade
Boss
Adapter
[BCF429H, BCF509H]
[BC329H, BC429H, BCF429H,
BCF509H]
Plate
[BC2259, BC2259H]
Gear case
Holding Tool
(3.5mmPin)
"A" Position
"B" Position
