Martinsound Martech Modular Studio Series, Owner'S Manual, Page: 16 / 28

10
In this example, the MSS-10 is placed in
the studio near the microphone or in the
control room next to the engineer, and
then connected to a console for mixing.
The Mic Preamp is selected to feed the
line driver, with the Mic Preamp Out con-
nected to a console. The Cal switch is
engaged to set the Mic Preamp Gain and
monitor the output with the VU meter.
Locating the MSS-10 near the microphone
keeps cable loss to a minimum for low
level microphone signals. This setup gives
the engineer the ability to set the best
gain and buffer the mic from a long cable
run. Final level is adjusted on a console
fader, permitting bussing and summing.
Locating the MSS-10 near the engineer
permits quick gain changes when required.
Also, the engineer can use the VU meter to
monitor the Mic Preamp Out level during
the recording process.
This method ensures the finest possible
signal integrity at the beginning of the
recording chain, where it matters the
most!
Mix to Taste!