MartinLogan SCRIPT i, User Manual

Page: 8 / 28

8 Mounting the Script i On A Wall
5 Set the wall bracket aside. Using a 1 /
8
" bit, drill a pilot
hole at all five points. If any of the pilot holes hit a stud
during this step, DO NOT widen the pilot hole and
install a wall anchor at that location. If a pilot hole does
not hit a stud, use a 1 /
4
" bit to widen the pilot hole and
using a Phillips screwdriver install the wall anchors so
they are flush with the wall (see figure 6).
6 Mount the wall bracket to the center wall anchor (or
pilot hole) using a 1" Phillips head screw driven through
the wall brackets center point. Do not fully tighten the
screw—the bracket must be vertically leveled before
installing the remaining screws. The cylindrical hinges
on the wall bracket should point away from the wall
and the hinge pins should point upwards towards the
ceiling (see figure 7).
7 Using a level, square the bracket and drive the four
remaining 1" Phillips head screws into the upper and
lower wall anchors (or pilot holes). Do not fully tighten
the screws (see figure 7).
8 Using a level, make sure the bracket is level and tighten
all five screws (see figure 7).
Figure 6.
Step 5
Figure 7.
Steps 6–8