MartinLogan SCRIPT i, User Manual

Page: 10 / 28

10 Mounting the Script i On A Wall
NOTE: Your Script i’s ship from the factory with the brackets
installed on opposite sides of each speaker. This allows 1
speaker to pivot clockwise and the other to pivot counter-
clockwise . Most installations will not require any alteration
to the bracket.
NOTE: These instructions describe how to change the
Script i’s wall and cabinet brackets so that the speaker will
rotate in the oposite direction.
Required hardware (included):
2.5mm Allen tool
6mm Allen tool
Required tools (not supplied):
1
/
8
" Allen tool
1 Prepare a flat surface with padding and sheets to pro-
tect the speaker as you work on it. Carefully place the
Script i face down on the work surface, using books or
pieces of cardboard to keep the speaker from rocking.
Using a 6mm Allen tool remove the 2 cap nuts located
on top of the cylindrical hinges and place them aside.
Carefully remove the wall bracket from the cabinet by
sliding it towards the bottom of the speaker (see figure 3).
2 Using a 2.5mm Allen tool carefully loosen the 2 set screws
that hold the 2 hinge pins in place (see figure 10, step A).
3 Remove the 2 hinge pins (see figure 10, step B).
4 Rotate the wall bracket 180 degrees (see figure 10, step C).
5 Reinstall the 2 hinge pins (see figure 10, step D).
6 Using a 2.5mm Allen tool, reinstall the 2 set screws to
lock the hinge pins in place. Make sure the set screw
tightens against the flat surface of the pin (see figure 10,
step E).
7 Using a
1
/
8
" Allen tool, remove 4 screws (2 each) from the
cabinet brackets (see figure 11).
8 Rotate the cabinet brackets 180 degrees and install them
on the oposite side of the cabinet (see figure 12).
Figure 10.
Changing the pivot direction of the Script i wall bracket.
Changing the Direction of Rotation
Figure 11. Removing the Script i cabinet brackets.