Martin RUSH Scanner 1 LED, User Manual, Page: 22 / 48

22 RUSH™ Scanner 1 LED User Manual
3. On the slave fixtures, use the UP and DOWN buttons to select from:
•
Slave 1 – fixture receives synchronizing information and runs the
same show as the master fixture, or
•
Slave 2 – fixture receives synchronizing information and runs a show
that is in sync with the master fixture’s show but is not identical to it.
4. Press ENTER to confirm your selection.
5. Select a pre-programmed standalone show on the Master fixture as
described above.
Sound activation (music trig)
The fixture’s built-in sound activation microphone can be used to trigger scene
changes with a music beat or other sound source when a fixture is running a
standalone show.
To set a chain of fixtures in Master/Slave mode to sound activation, you only
need to set up the Master fixture. Slave fixtures will synchronize with the
Master fixture.
When sound activation is running, the SOUND status LED on the control panel
flashes in sync with the music beat.
To set sound activation:
1. Select SOUND MODE and press ENTER to confirm. The current setting
will blink in the display.
2. Use the DOWN and UP buttons to select ON (sound activation enabled) or
OFF (sound activation disabled).
3. Press ENTER to confirm your selection.
Sound activation microphone sensitivity
To adjust the sensitivity of the sound activation microphone:
1. Play some typical music at the normal volume for the venue.
2. Select SOUND SENSE and press ENTER to confirm. The current setting
will blink on the display.
3. Use the DOWN and UP buttons to change the microphone sensitivity from
0 …100 until the fixture responds well to the music beat.
4. Press ENTER to confirm your selection.
Focus
Focus during standalone shows can be set for each gobo wheel: wheel 1
(rotating gobos) and wheel 2 (fixed gobos).
To set the focus for
the rotating gobo wheel:
1. Select FOCUS ADJUST and press ENTER.