Martin RUSH Scanner 1 LED, User Manual, Page: 21 / 48

RUSH™ Scanner 1 LED User Manual 21
Behavior without DMX (DMX State)
The DMX STATE setting determines how the fixture behaves when it is not
receiving a DMX signal. You can set the fixture to enter Show Mode, black out,
or hold the effect it was displaying when the DMX signal stopped. The fixture
is set to BLACKOUT by default.
To adjust the setting:
1. Select DMX STATE and press ENTER.
2. Use the DOWN and UP buttons to select SHOW MODE (fixture enters
Show Mode), BLACKOUT (fixture blacks out) or HOLD (fixture shows the
last effect it was displaying before the DMX signal stopped).
3. Press ENTER to save your selection.
Standalone settings
The fixture will operate in standalone mode if it is not receiving a DMX signal
and the DMX STATE menu option is set to SHOW MODE (see above), or if
you enter the SHOW MODE menu in the control panel.
Standalone show selection (Show Mode)
Nine pre-programmed standalone shows are available. To set the show that
the fixture will run in Show Mode:
1. Select SHOW MODE and press ENTER.
2. Use the DOWN and UP buttons to select a show from 0 to 8.
3. Press ENTER to save your selection.
Master/Slave mode
You can synchronize the standalone shows of fixtures on a data link using
Master/Slave mode. In this mode, the first fixture in the chain (the fixture that
does not have a DMX signal or another powered-on fixture connected to its
DMX IN connector) runs a preprogrammed or sound-activated standalone
show and the other fixtures run a standalone show that is synchronized with
the first fixture.
To set up Master/Slave operation:
1. Check that fixtures are linked in a chain with a DMX data cable.
2. Set all fixtures in the chain to DMX STATE
 SHOW MODE, and make
sure that no DMX signal is present on the data link. The first fixture on the
link will automatically act as master. All the other fixtures will act as slaves.
Fixtures’ MASTER and SLAVE LEDs light to indicate which mode they are
operating in.