36
MAC 401™ user manual
Onboard control menus
Single head module operation
When only one module is installed on the head, the
HEAD
menu is automatically set to
SNGL
. The MAC
401 automatically detects whether an RGB Zoom or CT Zoom module is installed and adjusts the control
menu accordingly. The following control menus are available:
Menu
Item
Options
Notes (Default settings in bold print)
ADDR
1
– XXX
DMX address (default address = 1). The DMX address range is limited
so that the fixture will always have enough DMX channels in the 512
available.
DMX
PSET
(fixture auto-
detects which
module is
installed and
displays either
RGB/HS
1
or
CT
2
menu
items)
RAWX
Non-calibrated RGB mode with dynamic effects
1
RGBX
Calibrated RGB mode with dynamic effects
1
HSX
HSV mode with dynamic effects
1
RAW
Non-calibrated RGB mode without dynamic effects
1
RGB
Calibrated RGB mode without dynamic effects
1
HS
HSV mode without dynamic effects
1
CTX
CT mode with dynamic effects
2
CT
CT mode without dynamic effects
2
PGRP
1
Individual control of 4 pixels (segments)
2H
Control of pixels in 2 groups of 2 pixels, horizontal split
2V
Control of pixels in 2 groups of 2 pixels, vertical split
All
All pixels controlled as one group
PINV
OFF
Disable pixel inversion
ON
Pixel inversion: pixels swapped left to right and top to bottom
PERS
PTST
PTSP
Pan and tilt speed normal / fast
SWAP
Swap pan and tilt (pan commands move tilt and vice versa) - off / on
PINV
Pan inversion (reverse direction pan control) - off / on
TINV
Tilt inversion (reverse direction tilt control) - off / on
FANS
REG
Cooling fan speed thermostatically regulated
FULL
Max. cooling fan speed
SLNT
Silent mode. When Silent mode is selected the head fan will turn off.
The base fan will still run. Values allowed for RGB or HSV (no matter
what operating mode) will be limited to prevent the fixture from
producing too much heat. If the LEDs get too hot the fans will revert to
Regulated mode. When the LEDs are cool enough the fans shift back to
Silent mode. The color wheel channel will have lower intensity in Silent
mode.
DIM
LIN
Linear dimming curve
SQR
Square law dimming curve
ISQR
Inverse square law dimming curve
SCUR
S-curve dimming curve
DRES
OFF
Disable reset via DMX
ON
Enable reset via DMX
DISP
ON
Display is permanently on
2MN
Display switches off and goes into Sleep mode if controls have not
been pressed for 2 minutes.
5MN
Display switches off and goes into Sleep mode if controls have not been
pressed for 5 minutes
10MN
Display switches off and goes into Sleep mode if controls have not been
pressed for 10 minutes
DINT
0-100
Display intensity. Default = 100%
ERRM
NORM
Display errors at 100% intensity (regardless of
DINT
setting) and
illuminate the service light.
SLNT
Silent error mode. The error message does not appear in the display,
but the service lamp is illuminated
CTC
(RGB Zoom
module only)
WITH
Sending a value on a CTC channel adjusts the temperature of
whatever color is currently being displayed on segment or fixture
INDP
Sending a value on a CTC channel overrides any color being displayed.
Fixture or segment switches to white with variable color temperature
Table 6: Control menu: single head module operation
