40
MAC 401™ user manual
REAR
(continued)
INFO
(continued)
PTMP
CURR
Display current average pixel PCB temperature
MSR
Display highest pixel PCB temperature since last reset
MR
Display highest pixel PCB temperature since manufacture
AIRF
TOTL
Current elapsed time in hours since the air filter was cleaned or
changed. Display the counter and press the up button for five seconds
to reset it.This counter must be reset manually when the air filter is
cleaned.
STTM
Set duration of time alert to be issued after 100-9999 hours have
passed on the
TOTL
counter, to remind you to clean it, particularly the
air filter. The alert appears as long as the value of the
TOTL
counter is
higher than the threshold set here.
SNUM
RDM
Display fixture’s RDM ID (this will be the same in the
FRNT
menu)
SNUM
Display fixture’s serial number (this will be the same in the
FRNT
menu)
MAN
RST
Reset fixture. Press [Enter] to confirm
ALL
0
–
255
All LEDs, intensity 0 - 100%
RED
or
WARM
0
–
255
Red if RGB module installed, Warm white if CT module installed,
intensity 0 - 100%
GRN1
0
–
255
Green 1 if RGB module installed, intensity 0 - 100%
Not displayed if CT module installed
GRN2
0
–
255
Green 2 if RGB module installed, intensity 0 - 100%
Not displayed if CT module installed
BLUE
or
COLD
0
–
255
Blue if RGB module installed, Cold white if CT module installed,
intensity 0 - 100%
ZOOM
0
–
255
Zoom full wide
→
zoom full narrow (Hypermode)
TILT
0
–
255
Full tilt
→
full opposite tilt
PAN
0
–
255
Pan full left
→
pan full right
TEST
TALL
Test LEDs, zoom and pan/tilt movement
T-FX
Test LEDs and zoom only
TP-T
Test pan/tilt movement only
TDIS
Light all segments in onboard display panel for 5 secs.
PERS
PTST
PTSP
Pan and tilt speed normal / fast
SWAP
Swap pan and tilt (pan commands move tilt and vice versa) - off / on
PINV
Pan inversion (reverse direction pan control) - off / on
TINV
Tilt inversion (reverse direction tilt control) - off / on
FANS
REG
Cooling fan speed thermostatically regulated
FULL
Max. cooling fan speed
SLNT
Silent mode. When Silent mode is selected the head fan will turn off.
The base fan will still run. Values allowed for RGB or HSV (no matter
what operating mode) will be limited to prevent the fixture from
producing too much heat. If the LEDs get too hot the fans will revert to
Regulated mode. When the LEDs are cool enough the fans shift back to
Silent mode. The color wheel channel will have lower intensity in Silent
mode.
DIM
LIN
Linear dimming curve
SQR
Square law dimming curve
ISQR
Inverse square law dimming curve
SCUR
S-curve dimming curve
DRES
OFF
Disable reset via DMX
ON
Enable reset via DMX
DISP
ON
Display is always on
2MN
Display switches off and goes into Sleep mode if the controls have
not been pressed for 2 minutes.
5MN
Display switches off and goes into Sleep mode if the controls have not
been pressed for 5 minutes
10MN
Display switches off and goes into Sleep mode if the controls have not
been pressed for 10 minutes
DINT
0-100
Display intensity. Default=100
Menu
Item
Item
Options
Notes (Default settings in bold print)
Table 7: Control menu: dual head module operation