42
MAC 350 Entour user manual
Display messages
Message
Appears when...
What to do
RST
(Reset)
... the fixture is indexing effects at startup.
Wait for reset to complete.
SRST
(Serial reset)
... the fixture has received a reset command
via DMX.
Wait for reset to complete.
You can set
PERS
→
DRES
to
OFF
to prevent accidental DMX reset
commands.
or
****
...there is no communication between the
control panel and motherboard (this display
appears briefly when powering the fixture on).
Check fuses.
Check cable and connectors between
control panel and motherboard.
Reinstall fixture software.
Contact Martin service if problem
continues.
CSER
(Check-sum error)
...a fixture software (firmware) upload is
unsuccessful.
Repeat the upload. Contact Martin
service personnel if problem continues.
HTSE
(Head temperature sensor error)
YTSE
(Yoke temperature sensor error)
LTCO
(LED temperature cutoff)
...one of the sensors is reporting temperature
above maximum or there is a problem with the
temperature sensing circuit. LEDs are shut
down.
Ensure free airflow around fixture.
Clean fixture.
Check that ambient temperature does
not exceed max. permitted level.
Contact Martin service personnel if
problem continues.
EFHA
...the effects hatch is open and power is
applied.
If you do not need access to effects,
close the effects hatch to restore
normal operation.
If this message appears while you are
trying to reset the fixture, close the
effects hatch fully and start the reset
again.
Note that the effects hatch must be
firmly clipped into the fully closed
position.
MERR
(Memory error)
...the EEPROM memory cannot be read.
Reset fixture.
If a pan/tilt error is displayed when you
attempt to reset the fixture, check that
the effects hatch is fully closed.
Upload new fixture software.
Contact Martin service personnel if
problem continues.
OPER
(Onboard programming error)
....there is a software programming error.
RAME
(RAM error)
....there is a RAM error.
COER
(Color wheel error)
G1ER
(Gobo wheel error)
...there is a malfunction in the color wheel or
gobo wheel positioning system.
FBEP
(Feedback error pan)
FBET
(Feedback error tilt)
FBER
(Feedback error pan/tilt)
...the pan and/or tilt correction systems cannot
correct a loss of step (or there is a malfunction
in the pan/tilt monitoring circuit such as a
defective sensor). After a time-out, the head
stops in a random position.
PAER
(Pan time-out)
TIER
(Tilt time-out)
FOER
(Focus time-out)
...there is a malfunction in the position
indexing circuit for pan, tilt or focus. After the
time-out, the fixture will establish a
mechanical stop and continue to work,
although calibration will be imprecise.
HTER
(Head temperature error)
YTER
(Yoke temperature error)
TL1E - TL7E
(Temperature error, LED 1 - LED7)
...there is a malfunction in one of the
temperature sensing circuits.
F1ER
(F1 = large fan on back of head)
F2ER
(F1 = small internal fan)
...there is a fan feedback error.
DRE1 - DRE7
(Driver error, drivers 1 - 7)
...one or more motor drivers fail.
DPER
(Display programming error)
...there is a display error.
SL1E - SL7E
(Sensor error, sensors 1 - 7)
...a sensor reports that it is short-circuited or
open.
Table 6: Display messages
