18
MAC 301 Wash user manual
3. Continue creating steps using the INSERT command in the control panel. Adjust the DMX values you
send to the fixture and use CAPT DMX each time you want to apply those values to a new step.
4. Reset and delete steps using the control panel commands.
Running a stand-alone program
Select RUN in the STANDALONE menu to start the fixture running its programmed sequence in a repeating
loop. To access the RUN command, you must unlock it by holding ENTER pressed in and pressing ESC.
Press ESC to stop stand-alone operation.
During stand-alone operation, S-ALONE 01/XX appears in the display, where XX is the current step in the
sequence.
Master-slave stand-alone operation
The MAC 301 Wash can operate in master-slave stand-alone mode, in which one ‘master’ MAC 301 Wash
fixture running a stand-alone program controls ‘slave’ MAC 301 Wash fixtures via DMX so that they run the
same program. This means that all fixtures run an identical synchronized program.
Important!
Before activating master-slave stand-alone operation in the MAC 301 Wash, disconnect any DMX
transmitting device (lighting desk, other fixture set to stand-alone master, etc.) that is connected to
it.
To set up master-slave stand-alone operation:
1. Create a stand-alone program in the master fixture as described above.
2. Set all fixtures apart from the master to REMOTE in the STANDALONE menu. To access the REMOTE
command, you must unlock it by holding ENTER pressed in and pressing ESC. If a slave fixture has
been set up with a stand-alone program, that stand-alone program is de-activated and the slave fixture
will only respond to DMX commands from the master fixture when you set the slave fixture to REMOTE.
3. Connect the DMX output of the master fixture to the DMX input of the first slave fixture and continue
connecting slave fixtures in a daisy-chain, DMX output to DMX input.
4. Select RUN in the master fixture’s STANDALONE menu. To access the RUN command, you must unlock
it by holding ENTER pressed in and pressing ESC. The master fixture will start running its programmed
sequence itself and in all the connected slave fixtures in a repeating loop.
Summary of Contents for MAC 301
