10
Installation and setting up
Installation and setting up
DANGER! DO NOT operate the haze machine until you have
read and observed all the precautions listed under “Safety
information” on page 4.
Locatio n
The Jem Ready 365™ is designed to be located on the floor. An optional trolley is
available which holds the machine, two gas cylinders and one AF1 MKII fan.
Ensure that there is at least 100mm clearance all round the machine and at least
60cm in front of the haze output.
AC power
Before using the machine, ensure that a grounding-type (earthed) power plug
that fits the local power outlets is installed on the Neutrik Powercon cable
provided.
DANGER! Make sure the power plug is correctly rated:
• For EU (230V) use fit a plug rated 10 amp minimum
• For US (120V) use fit a plug rated 10 amp minimum
When installing the plug, follow the plug manufacturer’s instructions and connect
pins as follows:
Yellow and green wire to ground (earth), blue wire to neutral and brown wire to
live.
The table below shows some common pin identification schemes.
wire function
marking
screw
colour
brown live
“L”
yellow
or
brass
blue neutral
“N” silver
green/yellow earth
green
Before connecting the haze machine to power, verify that the AC supply is
adequately dimensioned for the current draw of the machine. The machine
requires:
3.1A @ 230V (EU model)
6.2A @ 120V (US model)
Check that the local AC voltage is appropriate, as indicated on the machine’s
serial number label. If your AC voltage is outside the appropriate range, do not
use the machine. Contact Martin Service for assistance.
The Neutrik Powercon outlet connector is provided to power the
Jem AF1 or AF2 fan. No other equipment should be connected to
this outlet.
