![background image](http://html1.mh-extra.com/html/martin/freekie/freekie_user-manual_1732564009.webp)
DMX address setting
9
DMX
ADDRESS
SETTING
3
Each fixture connected to the serial link must have a DMX address, also known as a
start channel, which is the first channel the controller uses to send instructions to the
fixture. Fixtures of the same type that share the same address will mimic each
others behavior.
Freekie allows control of up to 12 fixtures or fixture groups. (A fixture group
comprises similar fixtures with the same DMX address.) The Freekie can control
the first 12 channels of each fixture, or group, and can activate smoke and strobe
fixtures. The Freekie assigns 12 channels to each fixture regardless of how many
channels it uses, therefore the DMX addresses have been pre-defined.
Assign the following addresses using the procedure that is required for each fixture
(refer to the user documentation for the fixture if you are in doubt as to the
procedure). The address is often set on the fixture using a DIP-switch, while others
use electronic address setting.
Freekie
fixture ID
DMX address DIP switch setting
1
1
2
13
3
25
4
37
Summary of Contents for Freekie
Page 1: ...Freekie user manual...
Page 4: ......