![background image](http://html1.mh-extra.com/html/martin/freekie/freekie_user-manual_1732564013.webp)
Controller set-up
13
8 Specify the dimmer/intensity channel by moving the fader that corresponds to the
dimmer/intensity channel of the luminaire (refer to the DMX protocol in the luminaire’s
user manual to find this), and then press ENTER.
9 Using the same fader set the minimum dimmer intensity value and press ENTER.
10 Using the same fader set the maximum dimmer intensity value and press ENTER.
11 You have now completed set up of this/these fixture/s. If:
• There are additional fixtures to set up then go back to step 4 and repeat these
steps.
• You have completed fixture configuration, then press EDIT to leave fixture set up
mode.
S T R O B E S E T - U P
The Freekie can control one or more strobe devices that have a DMX control
address of 145. During a show you can activate strobe effects using the STROBE
button. To configure strobe effects:
1 Press and hold EDIT for 3 seconds.
2 If the PIN-code function is enabled (see “Administrative functions” on page 22), you
will be prompted to enter the PIN code (factory set as “221174”). Use the fixture
buttons to select numbers. Press ENTER.
3 Press STROBE.
4 Set the strobe active scene (where the fixtures strobes) using the appropriate faders
(representing channels 1-12) and then press ENTER.
5 Set the inactive strobe scene (where the fixture does not strobe) using the
appropriate faders (representing channels 1-12) and then press ENTER.
6 Press EDIT to leave fixture set up mode.
Summary of Contents for Freekie
Page 1: ...Freekie user manual...
Page 4: ......