Martin Easypix 1200, User Manual, Page: 26 / 44

26 Easypix user manual
Setting up DMX-controlled operation
The Easypix Power can be controlled by sending instructions from a
DMX controller to the 3 DMX channels (out of the 512 channels
available in one DMX universe) the Easypix Power uses.
The first of these 3 channels is the Driver’s DMX address. You must set
the Easypix Power’s DMX address as a binary number on the unit’s
DIP switch and the controller must send instructions to that address
and the next two channels.
To save time calculating binary numbers, use Table 3. To use this table,
first find the DMX address in the main block in the table. Then read the
settings for pins 1 - 5 to the left and read the settings for pins 6 - 9
above the address. “0” means “OFF” and “1” means “ON”.
For example, to set the DMX address to 101, you need to set DIP
switch pins 1, 3, 6 and 7 to ON, as highlighted in the table.