3
User Manual
Thank you for selecting the Martin DMX Switch Pack. This DMX-controlled switching
device allows you to turn on and off up to six 350 watt devices with the Martin 2518 DMX
Controller or any other DMX board. It allows you to control non-intelligent lights; it is
ideal for combining fixtures from Martin’s DJ Series with intelligent lights.
The DMX Switch Pack is ruggedly built for years of trouble-free use. Setup and operation
are simple; please read this manual before setting up and operating the device.
S a f e t y i n f o r m a t i o n
W A R N I N G !
This product presents risks of lethal or severe injury.
This product is for professional use only. It is not for household use. Read this manual
before powering or installing the fixture, follow the safety precautions listed below and
observe all warnings in this manual and printed on the fixture. If you have questions about
how to operate the fixture safely, please contact your Martin dealer or call the Martin 24-
hour service hotline at +45 70 200 201.
To p r o t e c t y o u r s e l f a n d o t h e r s f r o m e l e c t r i c s h o c k
•
Disconnect the fixture from AC power before removing or installing fuses or any part,
and when not in use.
•
Always ground (earth) the fixture electrically.
•
Use only a source of AC power that complies with local building and electrical codes
and has both overload and ground-fault protection.
•
Do not expose the fixture to rain or moisture.
•
Refer all service to a qualified technician.
•
Never operate the fixture with missing or damaged covers.
To p r o t e c t y o u r s e l f a n d o t h e r s f r o m b u r n s a n d f i r e
•
Never use the device to power fixtures that exceed the specified maximum load.
•
Never attempt to bypass the fuses.
•
Always replace defective fuses with ones of the specified type and rating.
•
Do not modify the fixture or install other than genuine Martin parts.
To p r o t e c t y o u r s e l f a n d o t h e r s f r o m i n j u r y d u e t o f a l l s
•
When suspending the fixture above ground level, verify that the structure can hold at
least 10 times the weight of all installed devices.
•
Secure the device with a safety wire threaded through the side holes.
•
Block access below the work area whenever installing or removing the fixture.
