14
Martin DMX 5.3 and RDM 5.5 Splitters user manual
Table 1 shows some pin identification schemes. Consult a qualified
electrician if you have any doubts about proper installation.
Martin RDM 5.5 Splitter
The RDM 5.5 Splitter is supplied with a blue Neutrik PowerCon NAC3FCA
cable-mount connector for power input. The user must supply a suitable
length of power cable that meets the requirements listed on page 5 and
install the PowerCon connector on it as described below. The user must
then either hard-wire the power cable to the building’s electrical
installation, providing an easily accessible power on/off switch close to the
device, or install on the power cable a grounding-type (earthed) mains
plug that is suitable for the local power outlets, following the power plug
manufacturer’s instructions. Table 1 shows some pin identification
schemes. Consult a qualified electrician if you have any doubts about
proper installation.
Installing a Neutrik NAC3FCA power connector on a power cable
To install a Neutrik NAC3FCA input
connector on a power cable:
1. Slide the bushing over the cable.
2. Slide the white chuck over cables
with a diameter (D
a
) of 5 - 10 mm
(0.2 - 0.4 in.), or the black chuck
over cables with a diameter of 10
- 15 mm (0.4 - 0.6 in.).
3. Prepare the end of the cable by
stripping 20 mm (0.8 in.) of the cable’s outer jacket.
4. Strip 8 mm (1/3 in.) from the end of each of the wires.
Wire
(US system)
Wire
(EU system)
Pin
Marking
Screw color
black
brown
live
“L”
yellow or brass
white
blue
neutral
“N”
silver
green
yellow/green
ground
or
green
Table 1: Power plug pin identification
Chuck
Bushing
Housing
Insert
Cable end
Summary of Contents for DMX 5.3 Splitter
Page 1: ...Martin DMX 5 3 Splitter Martin RDM 5 5 Splitter user manual TM TM ...
Page 23: ...Block diagrams 23 Block diagrams Martin DMX 5 3 Splitter Martin RDM 5 5 Splitter ...
Page 27: ......
Page 28: ...www martin com Olof Palmes Allé 18 8200 Aarhus N Denmark Tel 45 8740 0000 Fax 45 8740 0010 ...