Physical installation
11
Physical installation
Mounting in a rig
Both the DMX 5.3 Splitter
and the RDM 5.5 Splitter
can be flown in a rig. To
install them in a rig:
1. Fasten a suitable rigging
clamp for the truss or
suspension bar to the
Splitter with a minimum
grade 8.8 M12 bolt as
shown in Figure 6.
Warning! The bolt
thread must protrude
10 mm (0.4 in.)
minimum and 25 mm
(0.9 in.) maximum into
the Splitter when the
bolt is tight.
2. Fasten the rigging clamp
securely to a truss or
suspension bar.
3. Loop a safety cable that
is approved for the
weight it will support
through the eyelet in the
back of the Splitter and
around the truss or
suspension bar.
Fastening to a surface
Both the DMX 5.3 Splitter and the RDM 5.5 Splitter can be fastened to a
flat, stable surface in any orientation. To fasten to a surface,
1. Fasten the supplied L-brackets to the outer ends of the Splitter using
the eight supplied Torx 10 M3 x 4 thread-forming screws as shown at
A
in Figure 7. The L-brackets can be fastened as shown at
A
or
rotated through 180°, allowing the Splitter to be fastened on or under a
surface with four suitable screws.
Figure 6: Mounting a rigging clamp
Eyelet for safety
cable
Rigging clamp
Rigging clamp
mounting bolt
protruding thread
Summary of Contents for DMX 5.3 Splitter
Page 1: ...Martin DMX 5 3 Splitter Martin RDM 5 5 Splitter user manual TM TM ...
Page 23: ...Block diagrams 23 Block diagrams Martin DMX 5 3 Splitter Martin RDM 5 5 Splitter ...
Page 27: ......
Page 28: ...www martin com Olof Palmes Allé 18 8200 Aarhus N Denmark Tel 45 8740 0000 Fax 45 8740 0010 ...
