Martin Yale 959, Installation, Operation & Maintenance Instructions Manual

Page: 2 / 16

(2)
1.0 Nomenclature
The nomenclature below will be used to describe accessories and
parts of your folder found in Fig. 1:
2.0 Basic Set-Up
Un-pack the folder and save all the packaging. Inside the main
carton, locate a box containing the 2 fold tables and box contain-
ing the feed table, exit table, these instructions, and a bag con-
taining 3 allen wrenches and the handwheel. Remove the card
board pad (s) from the bottom of the folder and place the
machine on a sturdy, flat table or bench.
CAUTION: Do not plug the power cord in until
the basic set-up is complete.
Begin the basic set-up as follows:
Handwheel: Install on the main roller shaft (Fig. 1).
Feed Table: With the allen wrench provided, loosen the guide
fingers and rotate them up and
away. Insert the front end of
the feed table onto the locator
pins near the 1st roller and
gently lower the back end
down onto the back pins (Fig.
2).
Note: Turn the handwheel counter clockwise while lowering the
table to easily engage the feed drive gears. Never drop or force
the table down, as this may result in damage to the drive gears.
Fold Tables: Install the fold tables onto the locator pins with
the folding (open) end towards the rollers (Fig. 3 & 4).
Note: Turn the
handwheel counter-
clockwise while
lowering the table
onto the back pins
for easier insertion.
Turn clockwise
when removing the
tables. Be sure the
tables are fully
seated on the pins.
Exit Table: Install exit
table by engaging tabs into
slots provided on the con-
veyor table (Fig. 5). Lower
into position as shown in
Fig. 1.
Accessory Shaft Journals:
Located on the side oppo-
site the handwheel are two
accessory shaft journals
(Fig. 6). These journals are factory installed. Due to vibration in
shipment, they may come loose. Check that the journal shafts are
pushed into the accessory shafts place and rotated clockwise to
lock in place. Test by pulling on the journals; they should not
come out.
1. Paper Guide Adjustment
2. Paper Guides
3. Feed Table
4. 3/4” Tie Rod
5. Paper Stop Release
6. Upr Fold Indicator Ruler
7. Paper Stop
8. 1st or Upper Fold Table
9. Micro Adjustment
10. Circuit Breaker
11. Simplified Fold Chart
12. Exit Table
13. Conveyor Table
14. Handwheel
15. On-Off Switch and
Variable Speed Control
16. Angular Control Adj.
17. Paper Guide Shaft Adj.
Screw
18. 2nd or Lower Fold Table
19. Retarder Assembly
20. Feed Tire
21. Auxiliary Feed Tire