***STEP 11 CONTINUED***
SETTING THE ADJUSTMENTS
Programs “A”, “B” and “C” must be followed precisly. Do not short cut the
programming process or the opener will soon become very erratic. If this happens,
follow “Clear Programmed Settings From Computer” on page 15 and start over again
by following Step 11 correctly.
Important:
Press
Press
Before beginning
This program will learn open and close travel limits and the first transmitter code.
Press
Note: The LEDs will blink while pressing the “+” and “-” buttons.
While
This program will learn the open and close weight of the door plus 15 lbs (7).
Press
Press
This program will memorize all settings.
Press
Press
Example of Programming Change:
, confirm that the garage door is the closed position, the trolley is
connected to the belt connector, and the #8 LED is illuminated showing that the power is on.
the “P” button for 3 seconds. The LEDs #8, #1, #2 should illuminate. See FIGURE 26
LEDs #6, #5, #4 should illuminate. See Figure 27
See Figure 27 LEDs #6 and #8 should illuminate, #7 should be blinking. See Figure 28
LED #7 is blinking, press and hold the desired button on the transmitter. When the
LED #7 blinks rapidly, release the transmitter button. The opener has now learned the
particular code of this transmitter (for additional transmitter programming see Figures 39,
39A, 39B). Press and release the "P" button. This stores the code in memory. As the LEDs
will fade out in a circular pattern the operational mode LEDs #4 and #8 should illuminate.
and release the "+" button. The door should open to its programed position.
and release the "-" button. The door should close to its programed position.
and release the transmitter button. The door should open to its programed position.
and release the transmitter button. The door should close to its programed position.
If the close limit needs to be changed, follow “A”
program, except press “P” button twice to bypass the open limit setting. After close limit
setting is completed, press “P” button twice to bypass transmitter code learning. LEDs #4
and #8 should illuminate. Complete “B” and “C” programs. End of programming.
“A” PROGRAM
“B” PROGRAM
“C” PROGRAM
END OF PROGRAMMING
Read “Note” on Page 15
and hold the "+" button until the door is in the opened position. Release this button. If
the door is not in the desired position, press the "+" button or the "-" button to move it
slightly. Once the door is in the desired position, press and release the "P" button. See
Figure 26
and hold the "-” button until the door is in the closed position. Release the button. If
the door is not in desired position, press the "+" or the "-" button to move it slightly. Do not
close door tight on floor. Once door is in desired position, press and release the "P" button.
COPYRIGHT © 2007 MARTIN DOOR
14
FIGURE 25
BEGIN PROGRAMMING
FIGURE 27
FIGURE 26
OPEN TRAVEL LIMIT
FIGURE 28
CLOSE TRAVEL LIMIT
TRANSMITTER PROGRAMMING
MARTIN
