Marta MT-4261, User Manual

Page: 10 / 16

10

To remove the rotisserie, first lift the left side of the rod so that it comes out of the slot holder, then remove the right side.
USING THE SKEWER

Loosen the clamps on the retainers.

Thread the rod through the square holes in the skewer (parallel to the shapruram).

Tighten the clamps.

Skewer the product you are going to cook.

Set the skewer with the right end in the drive hole in the center of the right wall inside the chamber, and the end with the cap in the slot holder located on the left wall of the chamber.

Set the desired temperature, then choose desired cooking modes by turning the knobs “5” & “6” and set the timer.

To avoid burns, use the supplied handle “8” and gloves (not included) to install and remove the skewer or the rotisserie.

To remove the skewer, first lift the left side of the rod so that it comes out of the slot holder, then remove the right side.
USING THE AIR FRYER

Loosen the clamps on the retainers.

Thread the rod through the square holes in the air fryer.

Tighten the clamps.

Open the door of the air fryer and put the product you are going to cook. Clode the door.

Set the air fryer with the right end in the drive hole in the center of the right wall inside the chamber, and the end with the cap in the slot holder located on the left wall of the chamber.

Set the desired temperature, then choose desired cooking modes by turning the knobs “5” & “6” and set the timer.

To remove the air fryer first lift the left side of the rod so that it comes out of the slot holder, then remove the right side.
SWITCHING OFF

The device will automatically turn off when the time set on the timer expires.

The device can be switched off at any time by turning the heating mode adjustment, temperature adjustment and timer knobs to the "OFF" position. An audible signal will sound, the light indicator
will go out, the device will stop working.

WARNING: Always turn off the unit when cooking is finished.

Disconnect the appliance from the power supply. Do not pull on the wire, only hold on to the plug. Always allow the appliance to cool down completely before you put it away.
CLEANING AND MAINTENANCE

Before cleaning, always unplug the appliance.

Use wet cloth to clean the device. Do not immerse the appliance in water or other liquids.

Clean accessories in soapy water and dry.

Do not use chemical and abrasive cleaners for cleaning.

Recommended to clean the device right after operating.
SPECIFICATION
Power supply Power, W Capacity, L
Net weight / Gross
weight, kg
Package size
(L х W х H), mm
Producer:
COSMOS FAR VIEW INTERNATIONAL LIMITED
Room 701, 16 apt, Lane 165, Rainbow North Street , Ningbo, China
Made in China
230 V ~ 50 Hz 2000 30 7,6 / 8,7 533 х 372 х 357
WARRANTY DOES NOT COVER SUPPLIES (filters, ceramic and non-stick coating, rubber seals, etc.)