Marshall Electronics VS-102-HDSDI, User Manual

Page: 14 / 62

VS-102-HDSDI User Manual
IP Server Instruction Manual
14/61
5. Connecting Power
After confirming the power source, connect the power adaptor and connect the 12VDC connector to the
system. The system will then boot up to an operating mode.
6. Check if it Works
Once the power is supplied to the camera, it will start booting. The system will boot up to an operating
mode after approximately 40-60 seconds. The green LED on the Ethernet port will flash indicating the
system is ready.
Software provided on the disc called True Manager allows you to check the IP address and other
network details of the camera. Please refer to the True Manager manual for instructions on how to find
the IP address of the camera and if required changing it.

Encoder LED Display
The LED status shown above shows that camera is connected but a decoder is not connected.
Once the encoder is connected to a decoder, color of “LINK” LED light will turn green and the “DATA”
LED
light will blink as video or audio transmissions occur.

Decoder LED Display
The LED status shown above shows that the Decoder has started without connecting to an encoder.
Once an encoder is connected, the color of “LINK” LED light will turn green and the “DATA” LED light will
blink as video or audio data transmissions occur.
PWR STATUS LINK
Red Green
Blinking
DATA
OFF
PWR STATUS LINK DATA
OFF
Red Green
Blinking
OFF