Marshall Electronics VS-101-HDSDI, User Manual

Page: 40 / 68

40
IP Server Instruction Manual
■ General
ƒ
Use record - On: Recording function in enabled when “On” is selected.
- Off: Recording function is disabled when “Off” is selected
ƒ
Select Video: Select the video source from either primary video or secondary video
ƒ
Overwrite: Selects option when the disk is full. If Overwrite is set to Off, the recording stops
automatically when there is less than 100MB free space in the disk. If Overwrite is set to
On , recording continues by deleting the oldest data first on disk, maintaining free space of
300MB for normal operation.
ƒ
Max File Size: The Max File Size option is for limiting the size of AVI file. If small file size
is set, files of small size will be generated while the number of the files will be increased. If
recording time is more than 10 minutes, new file will be created even though previous file
size is smaller than set max file size.
■ Event Type
ƒ
Three recording modes are supported in the VS-101-HDSDI: Continuous, Event,
Disconnect. Event recording, allows event types to be selected as a record start trigger.
Selected event types are used to configure the schedule table. Up to 4 event types can
be configured and each event type can be a combination of sensor, video loss and motion
event.
ƒ
Pre-event Time: Specify the duration of recording before an event happens.
ƒ
Post-event Time: Specify the duration after the event is cleared
■ Schedule Table
ƒ
The actual recording mode is determined by the Schedule Table, where recording modes are
configured by the day of the week and time of the day.
ƒ
Each of recording mode configures the recording operation as follows:
• Record off : The Record function is disabled and no recording will occur.
• Continuous : Records continuously
• Disconnect: Data is recorded when the system loses the connection to its client (Decoder,
CMS/NVR) etc. If one of multiple client systems is disconnected, this doesn’t happen.
• Event Type: Initiates Recording when an event configured in the Event Type setting occurs.
Encoder Configuration