Marshall Electronics VS-101-HDSDI, User Manual

Page: 12 / 68

12
IP Server Instruction Manual
Connecting Video
■ Encoder System
ƒ
Connecting the HD Camera
Connect the HDMI or HD-SDI output of the HD camera to the Appropriate HDMI or HD-
SDI Input port of VS-101-HDSDI. For HD-SDI the input dip switch should be set to the UP
position
ƒ
Connecting a standard resolution NTSC/PAL Camera
Connect the camera to the Video Input port of the VS-101-HDSDI. For standard NTSC/PAL
the video input dip switch should be set to the Down position.
■ Decoder System
Connect a monitor to the HDMI or COMPOSITE (HD-SDI) Output of the VS-101-HDSDI.
Connecting Audio
Audio is bidirectional regardless of the system mode (Encoder or Decoder).
If necessary, it can be configured to be transmit-only, receive -only or bidirectional mode
■ Connect the audio input and output ports to the appropriate audio devices as required.
■ The Audio I/O is -10dBu unbalanced line level stereo, appropriate microphone or speaker
amplification is required.
Connecting Serial Ports
Two serial ports are provided for remote camera control and PTZ controller receiver. These are
connected in connected in 1-to-1 fashion and work in a pass-through mode. This means that
commands at a local system’s COM1 port will be transparently passed to the remote system’s COM1
port. Also, a command at a local system COM2 port will pass to the remote system’s COM2 port.
Connecting Sensor and Alarm
Connect sensor and alarm devices to corresponding terminals as required.
Installation