![background image](http://html1.mh-extra.com/html/mars/comfort-aire-century-whdehum-90p/comfort-aire-century-whdehum-90p_installation-and-operation-manual_1730570009.webp)
Installation and Operation Manual -
WHDEHUM-90P
9
red. If in Unit/Standalone mode, press the button
a second time, and you will hear one beep as the
machine shuts down. Specially note that there
is a one minute fan delay from button push to
shutdown. In addition, the dehumidifier, once
configured for operation, will automatically return to
that mode during power glitch or outage.
If the dehumidifier is switched ON and then put
into Remote/Whole-House Mode, the unit cannot
be turned off with the switch. If in the Remote/
Whole-House Mode and you want to turn the main
power off, then switch the dehumidifier into Unit/
Standalone Mode that re-arms the OFF switch
(both mode indicator lamps off). Thereafter, the
power switch can be used to switch OFF.
2. Arrow Buttons ▲ Up and ▼ Down
Use the Up and Down arrow buttons to set the
humidity set point on the display screen, when
using in SUD configuration. The set points can be
any number between 35 to 99. Creating a set point
means that when the indoor humidity is lower than
the set point, the machine will stop automatically.
Conversely, when the indoor humidity is higher
than the set point, the button is pushed and the unit
will switch ON to run.
3. Central Control Configuration Button
Press this button to switch the dehumidifier
between Standalone Unit Configuration and Whole-
House Configuration. Whole-House Configuration
is selected when the green lamp is turned on
above.
Indicator Lights
1. Humidity Display Screen
The display screen has two functions. When the
unit is powered ON, it shows the local humidity.
While setting the desired humidity level, the screen
will show the set point humidity level.
2. Power Indicator Light
This light indicates that the unit is properly powered
ON and ready to operate in Standalone Mode. In
Remote/Whole-House Mode, the Power Indicator
only illuminates when the unit is running. Always
make sure this unit is OFF prior to performing any
service.
3. Continuous Mode/Auto Defrost Light
When this light illuminates green, it indicates that
the dehumidifier is set to Continuous Operation
Mode. When the light glows red, it means the unit
is in Auto Defrost Mode and clearing the evaporator
coil of any ice buildup.
4. Compressor Light
When the Compressor light glows red, it indicates
that the compressor has been initiated to run but is
currently warming up. Once the compressor light
switches to green, it indicates that the compressor
is in working status.
5. Whole-House Indicator Light
When the indicator light is green, it illustrates the
unit is configured for Whole-House Configuration
and not Standalone Mode. While in Whole-House
Configuration, the dehumidifier is to be controlled
by a separate humidistat.
Standalone Unit Configuration
After the dehumidifier is properly installed, ducted,
connected to AC power, and condensate drain
plumbed, standard operation can be configured
and initiated.
Step 1
Push the power switch to turn the dehumidifier
ON. TEST MODE can be initiated by switching
the dehumidifier into Standalone/Unit Mode then
by pressing and holding down both arrow buttons.
Configuration & Operation
Figure 6.
WHDEHUM-90P